Pyle PLR38I Instruction Manual page 6

IPod not recognized? Is iPod Enabled in the System Setting?
An iPod in the dock will only be recognized if the iPod function is enabled in the System
Settings. If the PLR38I-IPOD does not recognize that an iPod is present, check the
System Settings to make sure that the iPod function is enabled.
1.PLAY/PAUSE
Press to begin playback. To pause, press again. Press again to resume playback.
2.RPT (Repeat Play Mode)
Press this button to repeat the playback of the current track.
3.RDM (Shuffle Mode)
Press this button for shuffle playback of all the files in your iPod playlist.
4&5.I<< and >>I (Skip back/skip forward, Fast rewind/fast forward)
Press these buttons to skip back or ahead one track. Press and hold for fast rewind or fast
Forward.
iPod Dock adaptors
The PLR38I-IPOD comes with a set of special iPod adaptors which fit a wide rangeof iPod
models. These are specially designed for use with the PLR38I-IPOD, and hold the iPod firmly
to the dock connector when the vehicle is in motion.
Please install the appropriate dock adaptor as described below.
PLEASE NOTE:
"official"Apple Universal Dock Adaptors can not be used in the PLR38I-IPOD.
Do not attempt to connect you iPod to the dock without the appropriate,
specially-designed adaptor provided with the PLR38I-IPOD.
We can not accept any responsibility for any damage or date loss that may
result from using your iPod in the PLR38I-IPODIand the specially-desiged
dock adaptors.
1.Push on the face of the LCD to release
and open the iPod docking drawer.
2.Select the appropriate size dock adaptor
for your iPod. Lower it into the recess in
the drawer, aligning the notches/tabs on
the FRONT edge first.
PDF created with FinePrint pdfFactory trial version
Dock adaptor
http://www.pdffactory.com