Page 1
PLR38I INSTRUCTION MANUAL MULTIFUNCTION CAR AUDIO SYSTEM WITH AM/FM DIGITAL PLL TUNING RADIO MMC/SD USB/IPOD PLAYER Remarks: Any information subject to change without further notice PDF created with FinePrint pdfFactory trial version http://www.pdffactory.com...
Trouble Shooting Before going through the check list, check wiring connection. If any of the problems persist after check list has been made, consult your nearest service dealer. Front Panel Controls 1. VOLUME UP/DOWN KNOB (turn)& AUDIO MODE SELECTOR (push) In normal mode, use this knob to increase or decrease the volume level.
Push and hold the knob (like a button) for more than 2 seconds to turn on TA ON/TA OFF, then push it repeatedly to select TA SEEK/TA ALARM, PI SOUND/PI MUTE, RETUNE S/RETUNE L, MASK DPI/MASK ALL, BEEP ON /BEEP OFF, USER SET(FLAT, CLASSIC, ROCK, POP), VOL LAST/ VOL DEFA, STEREO/MONO(in RADIO mode), LOUD ON/LOUD OFF, DX/LOCAL(in RADIO mode), CLK ON/CLK OFF, CLK 12/CLK 24 mode.
Page 4
8.BAND Press briefly, repeatedly to cycle between the five radio bands: FM1 > FM2 > FM3 > AM1 > AM2 9&10. TUNE/SEEK UP/DOWN BUTTONS Press these buttons briefly to step up or down the radio dial in single step increments. Press and hold for more than one-haf second and the tuner will enter the SEEK mode.
Page 5
Press PLAY/PAUSE to begin playback. Most of the iPod ’s menu functions can be displayed and controlled by the PLR38I-IPOD. However, you can always control the iPod playback from the iPod itself if that is more convenient for you.
Page 6
Forward. iPod Dock adaptors The PLR38I-IPOD comes with a set of special iPod adaptors which fit a wide rangeof iPod models. These are specially designed for use with the PLR38I-IPOD, and hold the iPod firmly to the dock connector when the vehicle is in motion.
AUX input on the faceplate. Use the MODE switch to select AUX IN and use the controls on your iPod to play music through the PLR38I-IPOD. PDF created with FinePrint pdfFactory trial version...
JPLR38I-IPOD and the specially-designed dock adaptors. iPod charging The PLR38I-IPOD circuitry is designed to recharge your iPod, giving you many additional hours to enjoy listening to your library of music and Podcasts. Operation of Remote Control 1.POWER Use to turn receiver on/off...
8&9.TUNE/SEEK & I<< and >>I (Skip back/skip forward, fast back/fast forward) In radio mode, Press this button briefly to step up or down the radio dial in single step increments. Press and hold for a second to enter SEEK mode. In this mode the tuner will stop at the next strong station available.
Setting Mode You can make changes to the system setting in the following area:Radio Frequency Range + Enable/Disable AUX In+ Clock Format - Radio Settings The unit can operate on several different frequency ranges. Please see the following for these ranges.