Technical Parameters; Tuner Part; Installation Diagram - Pyle PLR35MPD User Manual

6. Technical Parameters

TUNER PART:

Frequency Range---------------------------------------------------87.5MHz-108MHz
Antenna terminal---------------------------------------------Connect the outside
antenna connector
Intermediate frequency------------------------------------------------------10.7MHZ
signal to noise ratio (S/N)----------------------------------------------------≥50dB
AM TUNER
Tuning range------------------------------------------------------------530-1710KHz
Usable sensitivity------------------------------------------------------------------38dB
Play part:
signal to noise ratio (S/N)-----------------------------------------------------≥50dB
Channel Separation (1KHZ) --------------------------------------------------- ≥50dB
Voltage Harmonic Distortion-------------------------------------------------------≤5%
Frequency Response -------------------------------------------- 100Hz-10kHz(+6dB)
Amplifier Part:
Out put------------------------------------------------------------------speaker out put
Speaker Impedenc -------------------------------------------------------------------4Ω
Max output power----------------------------------------------------50Wx4(200Watts)
Power SUPPLY VOLTAGE
battery (the negative pole connect ground, see on the unit in detail)
7. Cautions
When replacing fuse, please select the fuse of same specification, do not
replace it with others

8. Installation Diagram

PDF created with pdfFactory Pro trial version
----------------------------------------------------14.4V DC
www.pdffactory.com
1) Before install the main unit, please place the main unit at desired
position, connect the speaker wire and power wire for test use.
2) After the working effect of the main unit is ideal, fix the main unit.
○ Install the main unit
1. Install the support on the instrument panel of the car, bend the clamp of
the support.
2. Connect the power wire and speaker wire, fix the fixing piece on the
car.
3. Insert the antenna plug, push the main unit into the support, tighten
the fixing nut of the fixing piece.
○ Disassemble the main unit
Insert two disassembly keys into the left and right gap, make the keys
hook the main unit, pull out it to remove the main unit from the support,
then disassemble the connection wire and unplug the antenna plug.