Bridge Summary - ZyXEL Communications ZyWALL USG 200 Series User Manual

Chapter 13 Interfaces
remove from a bridge interface when the underlying interface is added or
removed.

13.9.1 Bridge Summary

This screen lists every bridge interface and virtual interface created on top of
bridge interfaces. To access this screen, click Configuration > Network >
Interface > Bridge.
Figure 286 Configuration > Network > Interface > Bridge
Each field is described in the following table.
Table 80 Configuration > Network > Interface > Bridge
LABEL
Add
Edit
Remove
Activate
Inactivate
Create Virtual
Interface
Object References Select an entry and click Object References to open a screen that
#
Status
Name
IP Address
Member
350
DESCRIPTION
Click this to create a new entry.
Double-click an entry or select it and click Edit to open a screen
where you can modify the entry's settings.
To remove an entry, select it and click Remove. The ZyWALL
confirms you want to remove it before doing so.
To turn on an entry, select it and click Activate.
To turn off an entry, select it and click Inactivate.
To open the screen where you can create a virtual interface, select an
interface and click Create Virtual Interface.
shows which settings use the entry. See
for an example.
This field is a sequential value, and it is not associated with any
interface.
This icon is lit when the entry is active and dimmed when the entry is
inactive.
This field displays the name of the interface.
This field displays the current IP address of the interface. If the IP
address is 0.0.0.0, the interface does not have an IP address yet.
This screen also shows whether the IP address is a static IP address
(STATIC) or dynamically assigned (DHCP). IP addresses are always
static in virtual interfaces.
This field displays the Ethernet interfaces and VLAN interfaces in the
bridge interface. It is blank for virtual interfaces.
Section 13.3.2 on page 306
ZyWALL USG 100/200 Series User's Guide