ZyXEL Communications ZyWALL USG 200 Series User Manual page 964

Appendix A Log Descriptions
Table 288 IKE Logs (continued)
LOG MESSAGE
VPN gateway %s was
enabled
XAUTH fail! My name:
%s
XAUTH fail! Remote
user: %s
XAUTH succeed! My
name: %s
XAUTH succeed! Remote
user: %s
Dynamic Tunnel
[%s:%s:0x%x:%s] built
successfully
Dynamic Tunnel
[%s:%s:0x%x:0x%x:%s]
rekeyed successfully
Tunnel
[%s:%s:0x%x:%s] built
successfully
Tunnel
[%s:%s:0x%x:0x%x:%s]
rekeyed successfully
Tunnel [%s:%s]
1 pre-shared key
mismatch
Tunnel [%s:%s]
Recving IKE request
Tunnel [%s:%s]
Sending IKE request
Tunnel [%s:0x%x] is
disconnected
Tunnel [%s] rekeyed
successfully
Table 289 IPSec Logs
LOG MESSAGE
Corrupt packet,
Inbound transform
operation fail
Encapsulated packet
too big with length
Get inbound transform
fail
964
DESCRIPTION
%s is the gateway name. An administrator enabled the VPN
gateway.
%s is the my xauth name. This indicates that my name is
invalid.
%s is the remote xauth name. This indicates that a remote
user's name is invalid.
%s is the my xauth name. This indicates that my name is
valid.
%s is the remote xauth name. This indicate that a remote
user's name is valid
The variables represent the phase 1 name, tunnel name, SPI
and the xauth name (optional). The phase-2 tunnel
negotiation is complete.
The variables represent the phase 1 name, tunnel name, old
SPI, new SPI and the xauth name (optional). The tunnel was
rekeyed successfully.
The variables represent the phase 1 name, tunnel name, SPI
and the xauth name (optional). The phase-2 tunnel
negotiation is complete.
The variables represent the phase 1 name, tunnel name, old
SPI, new SPI and the xauth name (optional). The tunnel was
rekeyed successfully.
The variables represent the phase 1 name and tunnel name.
Phase
When negotiating phase-1, the pre-shared keys did not
match.
The variables represent the phase 1 name and tunnel name.
The device received an IKE request.
The variables represent the phase 1 name and tunnel name.
The device sent an IKE request.
The variables represent the tunnel name and the SPI of a
tunnel that was disconnected.
%s is the tunnel name. The tunnel was rekeyed successfully.
DESCRIPTION
The device received corrupt IPsec packets and could not
process them.
An outgoing packet needed to be transformed but was longer
than 65535.
When performing inbound processing for incoming IPSEC
packets and ICMPs related to them, the engine cannot obtain
the transform context.
ZyWALL USG 100/200 Series User's Guide