Static Dhcp Edit - ZyXEL Communications ZyWALL USG 200 Series User Manual

Chapter 22 IP/MAC Binding
Table 112 Configuration > Network > IP/MAC Binding > Edit (continued)
LABEL
Enable
Logs for IP/
MAC
Binding
Violation
Static DHCP
Bindings
Add
Edit
Remove
#
IP Address
MAC Address
Description
OK
Cancel

22.2.2 Static DHCP Edit

Click Configuration > Network > IP/MAC Binding > Edit to open the IP/
MAC Binding Edit screen. Click the Add or Edit icon to open the following
screen. Use this screen to configure an interface's IP to MAC address binding
settings.
Figure 332 Configuration > Network > IP/MAC Binding > Edit > Add
442
DESCRIPTION
Select this option to have the ZyWALL generate a log if a device
connected to this interface attempts to use an IP address not assigned by
the ZyWALL.
This table lists the bound IP and MAC addresses. The ZyWALL checks this
table when it assigns IP addresses. If the computer's MAC address is in
the table, the ZyWALL assigns the corresponding IP address. You can
also access this table from the interface's edit screen.
Click this to create a new entry.
Double-click an entry or select it and click Edit to open a screen where
you can modify the entry's settings.
To remove an entry, select it and click Remove. The ZyWALL confirms
you want to remove it before doing so.
This is the index number of the static DHCP entry.
This is the IP address that the ZyWALL assigns to a device with the
entry's MAC address.
This is the MAC address of the device to which the ZyWALL assigns the
entry's IP address.
This helps identify the entry.
Click OK to save your changes back to the ZyWALL.
Click Cancel to exit this screen without saving.
ZyWALL USG 100/200 Series User's Guide