Bridge Summary - ZyXEL Communications ZyWall USG 2000 User Manual

Unified security gateway

Hide thumbs Also See for ZyWall USG 2000:

Table of Contents

Chapter 13 Interfaces

13.7.1 Bridge Summary

This screen lists every bridge interface and virtual interface created on top of

bridge interfaces. To access this screen, click Configuration > Network >

Interface > Bridge.

Figure 263 Configuration > Network > Interface > Bridge

Each field is described in the following table.

Table 73 Configuration > Network > Interface > Bridge

Create Virtual

Object References Select an entry and click Object References to open a screen that

Click this to create a new entry.

Double-click an entry or select it and click Edit to open a screen

where you can modify the entry's settings.

To remove an entry, select it and click Remove. The ZyWALL

confirms you want to remove it before doing so.

To turn on an entry, select it and click Activate.

To turn off an entry, select it and click Inactivate.

To open the screen where you can create a virtual interface, select an

interface and click Create Virtual Interface.

shows which settings use the entry. See

for an example.

This field is a sequential value, and it is not associated with any

This icon is lit when the entry is active and dimmed when the entry is

This field displays the name of the interface.

This field displays the current IP address of the interface. If the IP

address is 0.0.0.0, the interface does not have an IP address yet.

This screen also shows whether the IP address is a static IP address

(STATIC) or dynamically assigned (DHCP). IP addresses are always

static in virtual interfaces.

This field displays the Ethernet interfaces and VLAN interfaces in the

bridge interface. It is blank for virtual interfaces.

Click Apply to save your changes back to the ZyWALL.

Click Reset to return the screen to its last-saved settings.

Section 13.3.2 on page 297

ZyWALL USG 2000 User's Guide