ZyXEL Communications ZyWALL USG 200 Series User Manual page 738

Chapter 41 Addresses
• RANGE - a range address is defined by a Starting IP Address and an Ending
IP Address.
• SUBNET - a network address is defined by a Network IP address and
Netmask subnet mask.
The Address screen provides a summary of all addresses in the ZyWALL. To
access this screen, click Configuration > Object > Address > Address. Click a
column's heading cell to sort the table entries by that column's criteria. Click the
heading cell again to reverse the sort order.
Figure 494 Configuration > Object > Address > Address
The following table describes the labels in this screen. See
739 for more information as well.
Table 201 Configuration > Object > Address > Address
LABEL
Add
Edit
Remove
Object
References
#
Name
Type
Address
738
DESCRIPTION
Click this to create a new entry.
Double-click an entry or select it and click Edit to be able to modify the
entry's settings.
To remove an entry, select it and click Remove. The ZyWALL confirms
you want to remove it before doing so.
Select an entry and click Object References to open a screen that
shows which settings use the entry. See
an example.
This field is a sequential value, and it is not associated with a specific
address.
This field displays the configured name of each address object.
This field displays the type of each address object. "INTERFACE" means
the object uses the settings of one of the ZyWALL's interfaces.
This field displays the IP addresses represented by each address object.
If the object's settings are based on one of the ZyWALL's interfaces, the
name of the interface displays first followed by the object's current
address settings.
Section 41.2.1 on page
Section 13.3.2 on page 306
ZyWALL USG 100/200 Series User's Guide
for