ZyXEL Communications ZyWALL USG 200 Series User Manual page 881

Your configuration files or shell scripts can use "exit" or a command line consisting
of a single "!" to have the ZyWALL exit sub command mode.
Note: "exit" or "!'" must follow sub commands if it is to make the ZyWALL exit sub
command mode.
Line 3 in the following example exits sub command mode.
interface ge1
ip address dhcp
!
Lines 1 and 3 in the following example are comments and line 4 exits sub
command mode.
!
interface ge1
# this interface is a DHCP client
!
Lines 1 and 2 are comments. Line 5 exits sub command mode.
! this is from Joe
# on 2008/04/05
interface ge1
ip address dhcp
!
Errors in Configuration Files or Shell Scripts
When you apply a configuration file or run a shell script, the ZyWALL processes the
file line-by-line. The ZyWALL checks the first line and applies the line if no errors
are detected. Then it continues with the next line. If the ZyWALL finds an error, it
stops applying the configuration file or shell script and generates a log.
You can change the way a configuration file or shell script is applied. Include
setenv stop-on-error off in the configuration file or shell script. The ZyWALL
ignores any errors in the configuration file or shell script and applies all of the valid
commands. The ZyWALL still generates a log for any errors.
ZyWALL USG 100/200 Series User's Guide
Chapter 52 File Manager
881