The Static Route Screen - ZyXEL Communications P-870H Series User Manual

Chapter 12 Static Route

12.2 The Static Route Screen

Click Advanced > Static Route to open the Static Route screen.
Figure 87 Advanced > Static Route
The following table describes the labels in this screen.
Table 57 Advanced > Static Route
LABEL
#
Active
Destination
Netmask
Gateway
Interface
Remove
Add
Apply
158
DESCRIPTION
This is the number of an individual static route.
This field indicates whether the rule is active or not.
Clear the check box to disable the rule. Select the check box to enable it.
This parameter specifies the IP network address of the final destination.
Routing is always based on network number.
This parameter specifies the IP network subnet mask of the final
destination.
This is the IP address of the gateway. The gateway is a router or switch
on the same network segment as the device's LAN or WAN port. The
gateway helps forward packets to their destinations.
This is the WAN interface through which the traffic is routed.
Click the icon to remove a static route from the ZyXEL Device. A window
displays asking you to confirm that you want to delete the route.
Click this to create a new rule.
Click this to apply your changes to the ZyXEL Device.
P-870H/HW Series User's Guide