Wps Station Screen - ZyXEL Communications NBG-418N User Manual

Chapter 6 Wireless LAN
Table 33 Network > Wireless LAN > WPS (continued)
LABEL
Release
Configuration
Apply
Refresh

6.9 WPS Station Screen

Use this screen when you want to add a wireless station using WPS. To open this screen, click
Network > Wireless LAN > WPS Station tab.
Note: Note: After you click Push Button on this screen, you have to press a similar
button in the wireless station utility within 2 minutes. To add the second wireless
station, you have to press these buttons on both device and the wireless station
again after the first 2 minutes.
Figure 58 Network > Wireless LAN > WPS Station
The following table describes the labels in this screen.
Table 34 Network > Wireless LAN > WPS Station
LABEL
Push Button
Or input station's
PIN number
80
DESCRIPTION
This button is only available when the WPS status displays Configured.
Click this button to remove all configured wireless and wireless security settings for WPS
connections on the NBG-418N.
Click Apply to save your changes back to the NBG-418N.
Click Refresh to get this screen information afresh.
DESCRIPTION
Use this button when you use the PBC (Push Button Configuration) method to configure
wireless stations's wireless settings. See
Click this to start WPS-aware wireless station scanning and the wireless security
information synchronization.
Use this button when you use the PIN Configuration method to configure wireless station's
wireless settings. See Section 5.2.1.2 on page
Type the same PIN number generated in the wireless station's utility. Then click Start to
associate to each other and perform the wireless security information synchronization.
Section 5.2.1.1 on page 58.
59.
NBG-418N User's Guide