Deleting Memory Channels; Deleting Single Memory Channels; Deleting Whole Memory Banks In One Go; Scan Bank Link (Scan Group) - AOR AR8600 Operating Manual

7-6 Deleting memory channels

Although it is possible to over-write memory channels with new data, edit memory channels, swap, copy,
move and to PASS (skip) them, there will be occasions when you want to delete memory channels
completely.

7-6-1 Deleting single memory channels

While in memory read mode, to delete the currently
displayed memory channel. As a safe guard against accidental deletion you will be instructed to
to execute the deletion, alternatively to abort delete.
Once memory channels have been deleted, the data is destroyed and cannot be recalled again.

7-6-2 Deleting whole memory banks in one go

Should you wish to delete the entire contents of a memory bank, the DELETE menu may be used, this is
quicker than recalling each memory in memory read mode and deleting them individually, especially if
there are more than about five or six channels involved.
to access the DELETE menu. the key three times to
display the menu item "DELETE MEM-BANK B00". The LCD will display a memory bank location such
as "MEM-BANK B00" with the "B00" being the last memory bank used. Use the keys to select
the desired memory bank for deletion, alternatively type in the required bank letter via the keypad (the
CASE SHIFT key will be required to access the lower case memory banks). If there are no
channels which contain data in the selected memory bank, the LCD legend "B --" will be displayed with
"B" being the current bank and "--" indicating that no channels are available for recall or scan (as they
are empty).
To delete all memory channels from the displayed bank . After a few seconds the
LCD will display "DELETE MEM-BANK B--" indicating that the selected bank no longer contains memory
data. To exit the menu and return to the standard display .

7-7 Scan bank link (scan group)

It is possible to custom define scan parameters for a single bank or group of memory banks.
Use the key sequence to
access the "SCAN GROUP" menu. Bank "SCAN GROUP 0"
contains a default listing and cannot be overwritten (so displays
"LINK OFF" on the bottom line of the LCD), banks 1 to 9 are
available for custom programming.
Use the main dial or keys to select the SCAN GROUP
number, for SCAN-GROUP numbers 1 to 9 the legend
"BANK LINK" will be displayed on the bottom line of the LCD
indicating that programming is possible.