Programmed Edit Recording - Aiwa JAX-N3 Operating Instructions Manual

Programmed Edit Recording

As you program the CD tracks to record, Programmed Edit
Recording displays the remaining recording time for each side
of the tape, so you can easily select a set of desired tracks
within the length of your tape.
1 Insert the recordable tape in deck B.
2 Select the CD function and load disc(s).
En
3 Press SHIFT+EDIT twice on the remote.
"PRGM C-00" is displayed and "PGM" lights up.
4 Press the numbered buttons on the remote to
enter the length of the recordable tape.
10 to 99 minutes can be specified.
•r or t on the remote or MULTI JOG can also
be used to specify tape length.
5 Press DISC DIRECT PLAY 1-3 to select a disc
(only one disc is selectable).
Then, press the numbered buttons on the remote
to select the first track to be recorded on side A.
- To select the 10th track, press 0/10.
- To select the 20th track, press +10, +10 and 0/10.
- To select the 25th track, press +10, +10 and 5.
•DISC SKIP on the remote cannot be used to select a
disc.
6 Repeat step 5 to select the rest of the tracks for
side A.
The remaining recording time of side A is displayed. You
cannot select a track with a longer playing time.
7 Press SHIFT+EDIT on the remote to switch to side
B and select the tracks for the side.
8 Press SHIFT+EDIT on the remote to switch back
18
to side A.
9 Press wREC/REC MUTING to start recording on
side A.
The tape is rewound to the beginning of side A and
recording starts.
Go to the next step when recording on side A finishes.
10 Press SHIFT+EDIT on the remote to switch to
side B.
11 Turn over the tape, and press w REC/REC
MUTING to start recording on side B.
•Programmed Edit Recording cannot be used with MP3-CDs.
•You cannot program more than 30 tracks. "FULL" is
displayed.
•You cannot program a track with a track number larger than
30.
•Recording cannot start from a point halfway in the tape.
To stop recording
Press s. Recording and CD playback stop simultaneously.
To check the program
1 Before recording, press SHIFT+EDIT on the remote to select
side A or B.
2 Press r or t on the remote repeatedly or turn MULTI
JOG . The track number and program number are displayed
in succession.
To change the program of each side
Press SHIFT+ EDIT on the remote to select side A or B, and
press s to clear the program for the selected side. Then,
select tracks again.
To clear the edit program
Press s twice in stop mode.
To prevent accidental erasure
Remove the plastic tab of the cassette tape with a screwdriver
or other pointed tool. To record on the tape again, cover the
detection slot with adhesive tape.
Side A
Tab for side A