Tape Operations; Basic Recording - Aiwa JAX-N3 Operating Instructions Manual

TAPE OPERATIONS

TAPE A/B
MULTI JOG
En
PUSH EJECT
Deck A
SYNC DUB
Playback
Use only TYPE I (normal) tapes.
1 Press TAPE A/B (SHIFT+TAPE A/B on the remote)
and insert the tape in either deck.
Press zPUSH EJECT to open the cassette holder, and
insert with the exposed side down and playback side
facing out from the unit. Push zPUSH EJECT to close.
PUSH EJECT
2 Press c(c/don the remote).
16
DISC DIRECT
PLAY 1-3
EDIT
PUSH EJECT
Deck B
REC/
REC MUTING
To stop playback
Press s.
To pause playback (deck B only)
Press a. Press again to resume.
To fast forward or rewind
Press f or g.
To select a deck (deck A or deck B)
Press TAPE A/B (SHIFT+TAPE A/B on the remote) in stop mode
when tapes are loaded in both decks.
"TP A" (deck A) or "TP B" (deck B) is displayed.
To reset the tape counter
Press s in stop mode, and the tape counter in the display is
reset to "0000". Opening and closing the cassette holder
will also reset the tape counter.
To play continuously (deck A to deck B)
Load tapes in both decks and start playback on deck A. Then,
as soon as playback on deck A finishes, playback on deck B
will start without interruption.
•The both decks play one side of the tapes.
Notes on cassettes
1–0/10,
+10
•Use of a tape longer than 90 minutes is not recommended
TAPE A/B
since they are extremely thin and easily damaged. If you
DISC SKIP
should use it, do not change the tape operations such as
play and stop frequently.
•Take up any slack in the tape with a pencil or similar tool
before use. Slack tape may get entangled in the deck
mechanism and become damaged.

Basic recording

Use only TYPE I (normal) tapes. Deck B is the recording deck.
SHIFT
Only one side of the tape can be recorded at a time.
1 Insert the recordable tape in deck B.
Press zPUSH EJECT to open the cassette holder, and
insert with the exposed side down and the side to be
recorded on facing out from the unit.
Wind up the tape to the desired point if needed.
2 Prepare the source.
To record CD(s), select the CD function and load disc(s).
To record a radio program, tune in to the desired station.
To record a tape, insert the source tape in deck A and
select the TAPE (deck A) function.
To record from connected external equipment, select the
VIDEO/AUX function and prepare the equipment.
3 Press wREC/REC MUTING to start recording.
When recording a CD or tape, playback starts
automatically.
When recording input from connected equipment,
manually start playback of the source.
•Volume or tone adjustment does not affect recording.
•"NO TAB" is displayed if you attempt to record a tape
with the tab broken off.