Cisco Network Convergence System 6000 Series Unpacking, Moving, And Securing Manual page 20

Dolly Specifications
Figure 1-7
Swing the lift arm swing bracket to the side (180-degree position as shown in
Step 6
holding bolts and partially tighten the bolts.
Repeat Step 1 through Step 6 for the other dolly unit.
Step 7
configuration.
Step 8 Lock the dolly caster brakes and anti-rotation pins until you are ready to move the chassis.
Step 9 Using the 3/8-inch ratchet wrench with 12-mm hex bit, firmly tighten the holding bolts on both dolly
units.
Note
Cisco Network Convergence System 6000 Series Routers Unpacking, Moving, and Securing Guide
1-12
Chassis Dolly—Removing Holding Bolts and Swinging Arm Out to 180-Degrees
To change the configuration back to the 90-degree configuration, repeat these steps and swing
the arm into the 90-degree position.
Figure
Figure 1-6 shows the dolly in a 180-degree
Chapter 1
1-7). Reinsert the
OL-29233-01