Gps Troubleshooting Guide - Garmin Rino 130 Owner's Manual

Appendix
Symptom
Unit does not turn On.
Unit does not turn On, even with new batteries.
The unit turns On, then turns Off.
It takes more than ten minutes to get a location fix.
Cannot access a WAAS system satellite after 2 to 5
minutes.
Cannot obtain a differential position from WAAS.
Cannot access Point of Interest, Street, or Intersection
Find Lists.
Cannot view a track being laid down on the map page
when traveling.
Cannot see the panning arrow on the Map Page easily.
Cannot exit a menu or page by moving the THUMB
STICK to the LEFT.
104

GPS Troubleshooting Guide

To resolve problems that cannot be remedied using this guide, contact Garmin Customer
Service at 913-397-8200 or 800-800-1020
Probable Cause
Batteries are exhausted.
Batteries may be installed backwards.
You are pressing and releasing the Power button.
Batteries may be nearly exhausted.
The unit' s view of satellites is obstructed.
Your view of the satellite is obstructed or you are
located too far from satellites currently in service for the
Americas.
System GPS operation is set to something other 'Normal'
and/or interface setting is for RTCM.
You have not collected enough information from the
WAAS satellite.
MetroGuide map data is not activated.
The Track Log feature is turned Off.
There is too much map clutter or the scale is such that
map features are too densely displayed
Some menus and pages have an 'X' (Exit) on-screen but-
ton in the upper right corner.
.
Remedy
Replace batteries.
Reinstall batteries.
You must press and hold the Power button for 2 seconds.
Replace batteries.
Move to a location with a clear view of the sky.
Move to a location with a clear view and point the unit
antenna in the direction of the satellite.
Set system GPS to 'Normal' and interface to other than
RTCM. Or simply turn off WAAS.
Wait 10–20 minutes for the initial collection, then 1–2
minutes afterwards.
Access the Map Setup 'Map' option and activate the check
box.
Access the Tracks Page, highlight the 'On' button and
press the THUMB STICK IN.
Use the Map Page Setup Page to reduce map clutter or
change the map scale.
Highlight the on-screen button and then press the
THUMB STICK IN.