For your safety, the information
in this manual
must be followed
the risk of fire or explosion,
or to prevent property
injury, or death.
= Do not store or use gasoline or other flammable
vapors and liquids in the vicinity of this
or any other appliance.
= WHAT TO DO iF YOU SMELL GAS:
• Do not try to light any appliance.
• Do not touch
do not use any phone in your
• Clear the room, building,
or area of all occupants.
call your gas supplier
from a neighbor's
the gas supplier's
• if you cannot
call the fire department.
must be performed
by a qualified
the gas supplier.
In the State of Massachusetts,
the following installation instructions apply:
 Installations and repairs must be performed by a qualified or licensed contractor, plumber, or gasfitter qualified or licensed by
the State of Massachusetts.
 If using a ball valve, it shall be a T-handle type.
 A flexible gas connector, when used, must not exceed 3 feet.
To reduce the risk of fire, electric shock, or injury to persons when using the dryer, follow basic precautions,
including the following:
Read all instructions
before using the dryer.
Do not place items exposed to cooking
oils in your dryer.
oils may contribute
reaction that could cause a load to catch fire.
Do not repair or replace any part of the dryer or attempt
any servicing unless specifically recommended
Use and Care Guide or in published user-repair instruc-
tions that you understand and have the skills to carry out.
Do not dry articles that have been previously cleaned in,
washed in, soaked in, or spotted with gasoline, dry-
cleaning solvents, other flammable,
as they give off vapors that could ignite or
Do not allow children to play on or in the dryer. Close
of children is necessary when the dryer is
used near children.
Before the dryer is removed from service or discarded,
remove the door to the drying compartment.
Do not reach into the dryer if the drum is moving.
Do not install or store the dryer where it will be exposed
to the weather.
Do not tamper with controls.
Do not use fabric softeners or products to eliminate static
by the manufacturer
of the fabric
softener or product.
Do not use heat to dry articles containing foam rubber or
similarly textured rubber-like materials.
Clean lint screen before or after each load.
Keep area around the exhaust opening and adjacent sur-
rounding areas free from the accumulation
The interior of the dryer and exhaust vent should be
by qualified service personnel.
See installation instructions
for grounding requirements.
SAVE THESE iNSTRUCTiONS
iMPORTANT: The gas installation must conform with local codes, or in the absence of local codes, with the National Fuel Gas
Code, ANSi Z223.1/NFPA 54 or the Canadian Natural Gas and Propane installation Code, CSA B149.1.
The dryer must be electrically grounded in accordance with local codes, or in the absence of local codes, with the National
Electrical Code, ANSI/NFPA 70 or Canadian Electrical Code, CSA O22.1.