Advertisement
Quick Links
®
EIP-WX5000/WX5000L Quick Guide
This Quick Guide shows the basic operation (projector connecting with the
computer using an RGB cable). Before using the projector, please read the
Owner's Manual carefully.
Setup and Projection
5
3 8
6
7
4 6
6
4
1.
Place the projector facing a screen
2.
Connect the projector to the computer and plug the power cord
into the AC socket of the projector
3.
Remove the lens cap and turn the projector on
Press STANDBY-ON on the projector or on the remote
control.
3 8
5
4
6
7
4
6
7
4.
Adjust the angle
Adjust the projector angle:
•
Shift the lens horizontally and vertically.
1 Press H&V LENS SHIFT on the projector or on the remote control.
2 Press ', ", \ or | on the projector or the remote control.
•
Adjust the projector angle by rotating the adjustment feet.
5.
Adjust the focus and the zoom
1 Press FOCUS +/– on the projector or on the remote control to adjust the focus.
2 Press ZOOM +/– on the projector or on the remote control to adjust the zoom.
6.
Correcting the image distortion due to the projection angle
1 Press KEYSTONE on the projector or on the
remote control.
2 Press ENTER on the projector or on the
remote control.
3 Press ', ", \ or | to move the position for
the upper left of the image.
7.
Select the input mode
Press INPUT on the projector or COMPUTER1 on the remote control to select the "COMPUTER1" mode.
On the
On the remote
projector
control
Switching the Input Mode:
•
When you press INPUT on the projector, the INPUT list appears.
Press '/" to switch the INPUT mode and then press ENTER.
•
When using the remote control, press COMPUTER1/2, DVI, HDMI, VIDEO or S-VIDEO to switch the
input mode.
8.
Turn the power off
Press STANDBY-ON on the projector or on the remote control. While the confirmation message is
displayed, press STANDBY-ON again.
" " On-screen Displa y
" "
"
•
You can unplug the power cord even if the projector is operating.
•
Even if you unplug the power cord from the AC outlet, the cooling fan continues to run for a while.
4 Press ENTER to set the position.
5 Repeat the same procedure with the positions
for the upper right, lower right and lower left of
the image.
•
When the position of the lower left is set, the
correction is made and the display disappears.
INPUT list
On-screen Display (RGB)
Printed in China
XXXXXXXXXXXXX
08P07-CH-NM
Advertisement
