Table of Contents
Advertisement
CLI Commands, Continued...
Show or Set N-Ring Configuration
Command Name
Description
Syntax
Parameters
Examples
NOTES
Show or Set N-View Configuration
Command Name
Description
Syntax
Parameters
Examples
NOTES
(Revised 2012-05-01)
Nring
Show or set N-Ring configuration. If no parameters are specified, this command will
show the N-Ring configuration (same as -show parameter).
nring [-show] [-mode d | a | m] [-ports set_id]
-show
Show configuration.
-mode
Set the N-Ring mode.
d = disabled, a = auto member, m = manager
-ports set_id
Set the ring ports for N-Ring manager mode.
Specify port set identifier or use '?' to list available port sets.
N-TRON/Admin> nring –show
N-Ring Mode
: Auto Member
Aging Time
: 20
N-TRON/Admin> nring -ports ?
ID
Port Set
--
--------
1
TX1 / TX2
2
TX7 / TX8
3
GB1 / GB2
N-TRON/Admin> nring –mode m –ports 2
Do you Want to Save Changes and Restart the System Now [y/n]?
...
Nview
Show or set N-View configuration. If no parameters are specified, this command will
show the N-View configuration (same as -show parameter).
nview [-show] [-status state]
-show
Show configuration.
-status state
Set the N-View status to e(nabled) or d(isabled).
N-TRON/Admin> nview –show
N-View Status
: Enabled
N-View Interval : 5
N-TRON/Admin> nview –status disabled
N-View Status
: Disabled
N-View Interval : 5
Changes have been made that have not been saved.
...
Page 146 of 170
Advertisement
Table of Contents
