Table of Contents
Advertisement
DIN RAIL MOUNTING
Install the unit on a standard 35mm Din-Rail. Recess the unit to allow at least 3" of horizontal clearance for
copper cable bend radius. Recess the unit to allow at least 5" of horizontal clearance for fiber cable bend
radius. There should be at least 3" of clearance on both the top and bottom of the unit to allow proper
ventilation.
To install the unit to 35mm industrial DIN rail,
place the top edge of the included mounting
bracket on the back of the unit against the DIN rail
at a 15° angle as shown. Rotate the bottom of the
unit to the back (away from you) until it snaps into
place.
Most N-Tron™ products are designed to be mounted on industry standard 35mm DIN rail. However, DIN
rail mounting may not be suitable for all applications. Our Optional Universal Rack Mount Kit (P/N:
URMK) may be used to mount the enclosure to standard 19" racks, and our Optional Factory Installed Panel
Mount Assembly may be used to mount the enclosure to a panel or any other flat surface.
(Revised 2012-05-01)
URMK
To remove the unit from the 35mm industrial
DIN rail, pull forward on the unit until it disengages
from the bottom of
the DIN rail. Rotate
the bottom of the unit
towards you and up at
an approximate 15°
upward
angle
to
completely
remove
the unit.
CPMA
Page 12 of 170
Advertisement
Table of Contents
