Base And Toe Panel; Final Instructions - Kenmore 63016302400 Installation Manual

ELECTRICAL CONNECTION
(continued)
WARNmNG: FIRE HAZARD -
LOOSE OR mMPROPER ELECTRICAL
CONNECTmONS CAN CAUSE FIRE.
MAKE CERTAIN THAT ALL ELECTRI-
CAL CONNECTmONS ARE PROPERLY
MADE°
Do not pre°twist the wires before connecting them
with wire nuts,
Extend the dishwasher's stranded wires 1/8" (3mm)
beyond the power suppHycabHe's solid wires, as
shown in Figure 22,
5) Using the supplied wire nuts, connect the eHectricaH
suppHy wires to the dishwasher's wires, bHackto bHack,
white to white, and green or bare to green or bare,
Make certain that the insuHated wires show no bare
wire from the bottoms of the wire nuts, GentHytug the
wires to make certain they are secureHy connected,
6) Press the wires into the junction box, Make certain
that the wire nuts do not Hoosen,
7) PHacethe cover on the junction box and secure it to
the junction box with the suppHied screw,
BASE AND TOE PANEL
Use the suppHied toe paneHscrews (Figure 1, HetterB)
from the Dishwasher HnstaHHation Kit and a Torx screw°
driver to instaHH the toe paneHas shown in Figure 23,
FINAL INSTRUCTIONS
1) Energize the dishwasher power suppHy circuit,
2) ConsuHt the Use and Care Guide that came with your
dishwasher, and run the dishwasher through one com-
pHetecycHe, Hf t he dishwasher does not operate properHy,
refer to the troubHeshooting section of the Use and Care
Guide,
Stranded Wire
Solid Wire
Figure 23
E_ectrica_ Connection/Base and Toe Pane_/Fina_ Instructions 13