The Control Panel - Kenmore 263.1462 Series Use & Care Manual

7 THE CONTROL PANEL

1. Power Button
2. Cycle Buttons
3. Display
4. Delay Hours Buttons
5. Half Load Button
6. Extra Dry Button
7. Sani Rinse Button
8. High Temp Button
9. Accela Wash Button
10. Quiet Wash Button
11. Start/Pause Button
12. Rinse Aid Indicator
13. End Step Indicator
14. Sanitized Indicator
15. Delay Indicator
16. Upper Half Load Indicator
17. Lower Half Load Indicator
18. Cycle Time Indicator
1. Power Button
Turn the machine on by pressing the Power
button.
2. Cycle Buttons
Select a suitable cycle for your dishes by pressing
Cycle buttons. For the details of the cycles refer
to section Cycle Table.
3. Display
The display shows the total time of the selected
cycle and the remaining time during operation.
4. Delay Hours Buttons
Press the Delay Hours Buttons to delay the
start time of a cycle for 1 hour up to 24 hours.
Pressing once to + button will delay the start time
for 1 hour. Once you press it, display will show
"1h" and display will show cycle duration and
delay time alternately for 2 seconds. Continuing
to press the button will increase the delay
duration. Press the - button to decrase
the delay duration. In order to start the selected
cycle with delay, Start/Pause button(11) should
be pressed and the door of the dishwasher
must be closed within 4 seconds. If you turn off
the machine after activating the delay time, the
delayed time is cancelled.
5. Half Load Button
There is a half load option with three modes.
Use the half load feature to direct cleaning to
the desired rack when the dishwasher is not fully
loaded. When the half load button is pressed,
the indicator(s) on the control panel will illuminate
according to the selections. If the half load
button is pressed once, the upper half load
indicator will illuminate. If the button is pressed
a second time, the lower half load indicator
will illuminate. If the button is pressed a third
time, the upper half load and lower half load
indicators will both illuminate. This mode will
shorten the length of cycle and reduce energy
and water consumption. After the fourth press,
the indicators will go off and the feature will not
be activated.
6. Extra Dry Button
Press the Extra Dry button to add extra drying
steps to a cycle in order to obtain drier dishes.
This option increases water temperature of the
final rinse step and duration of the drying step.
Extra Dry led will be on.
7. Sani Rinse Button
Sani Rinse function raises the water temperature
in the final rinse. Sani Rinse led will be on.
USA - CAN - 25