Base And Toe Panel; Final Instructions - Kenmore Dishwasher Installation Instructions Manual

ELECTRICAL CONNECTION
(continued)
WARNING: FIRE HAZARD -
LOOSE OR IMPROPER ELECTRICAL
CONNECTIONS CAN CAUSE FIRE.
MAKE CERTAIN THAT ALL ELECTRI-
CAL CONNECTIONS ARE PROPERLY
MADE.
• Do not pre-twist the wires before connecting them
with wire nuts.
• Extend the dishwasher's stranded wires 1/8" (3mm)
beyond the power supply cable's solid wires, as
shown in Figure 22.
5) Using the supplied wire nuts, connect the electrical
supply wires to the dishwasher's wires, black to black,
white to white, and green or bare to green or bare.
Make certain that the insulated wires show no bare
wire from the bottoms of the wire nuts. Gently tug the
wires to make certain they are securely connected.
6) Press the wires into the junction box. Make certain
that the wire nuts do not loosen.
7) Place the cover on the junction box and secure it to
the junction box with the supplied screw.

BASE AND TOE PANEL

Use the supplied toe panel screws (Figure 1, letter B)
from the Dishwasher Installation Kit and a Torx screw-
driver to install the toe panel as shown in Figure 23.

FINAL INSTRUCTIONS

1) Energize the dishwasher power supply circuit.
2) Consult the Use and Care Guide that came with your
dishwasher, and run the dishwasher through one com-
plete cycle. If the dishwasher does not operate properly,
refer to the troubleshooting section of the Use and Care
Guide.
Electrical Connection/Base and Toe Panel/Final Instructions
Stranded Wire
Solid Wire
Figure 22
Figure 23
1/8"
3mm
13