4.17 LED board
4.17
LED Board
Removing the LED Board
Remove the LED board according to the following procedures and Figure 4-41.
NOTE: Be carefully peel away the 3 tapes securing the board before you can remove it.
1. Remove the ESD tape for fix LED flat cable.
2. Remove the left and right sides fix touch pad ESD tape.
3. Remove the two M2.5x3 flat round head screws.
4. Disconnect the touch pad flat cables from J1 on the touch pad and remove the LED board.
5. Disconnect the touch pad flat cables from CN2000 and LED board flat cable from
CN2002 on the LED board.
LED SUMI-card
LED board
CN2002
M2.5x3 flat-round-head screw
Equium A60/ Satellite A60/ Pro A60/ A65 Maintenance Manual
ESD tape
CN2000
Touch pad SUMI-card
Figure 4-41 Removing the LED board
4 Replacement Procedures
ESD tape
J 1
4-59