Sew A Button - Kenmore 385.12612090 Owner's Manual

SECT!ON 3. LEARN THE STITCHES
Sew a Button
Sat the Machine
Stitch Stitch selector
Top thread tension Stitch length control
control 't to 4 any number (no?
necessary to adjust)
Zigzag foot
Darnmg plate
!ii';
!!i!
Use the darning plate for button sewin {see p. 18).
I
1. Set the stitch selector at" €_ "
2. Align the both holes of the button with the slot of the foot and place the left
hole of the button just below the needle point.
3+ Lower the foot and turn the stitch selector to zigzag until the needle point
comes just above the right hole of the button,
4. Sew about five stitches and rinse needle.
5. Set the stitch selector at "' c_ again and sew a few stitches to _ock thread.
To strengthen the shank, cut the
threads leaving a 20 cm (8") tail. Bring
the needle thread down through the
hole in the button and wind it around
the shank.
Draw the thread to the bottom side
and knot.
23