Clean The Shuttle Race - Kenmore 385.12612090 Owner's Manual

SECTION 5. CARE FOR YOUR MACHINE
= Clean the Shuttle Race
This area must be kept free of dust, lint and occasional tangled thread. Clean the shuttle race area
about every three months.
Center ptn o{
the shutt]e
Lever
Lever
case
Shuttte driver
Leve
Shuttle Race L
(Oil here)
Lever
Pointed
Shuttle
Shuttle Race
Cover
To Clean the Shuttle Area:
1, Raise the needle bar to its highest
point and remove the bobbin case.
2. Push shuttle race levers aside. Lift
shuttle race cover and take shuttle out.
3. Clean the shuttle race with a iint
brush.
4. Put a drop of oif on the center pin of
the shuttle and shuttle race. Do not
over-oil.
To Replace Shuttle Assembly:
1, Position shuttle race as illustrated so that shuttle
driver is forming half moon on the left side of the
machme.
2. Ho_d shuttle by center pm and posit=on shuttle so as
to form a half moon on the right side. P6inted hook
will be on the bottom.
3. Place shuttle race cover into place over shuttle
assembly.
4. Snap the levers back into the original position,
37