Sew A Button - Kenmore 19502 Owner's Manual

Sew a Button
Setthe Machine
Stitch width control
button
"Press
B: Transparent
buttonhole
foot
Darning 01ate
Thread tension
3to7
Left hole
Right hole
Use the darning plate for button sewing (see p. 3i6). 5.
1. Match the button holes to the horizontal slot
on the presser foot.
6.
2. Lower the foot to hold the button in place.
7.
3. Turn the hand wheel by hand until the needle
point is just above the button.
8.
4. Press the stitch width button (+ or -) so the
needle will enter the lef.__t h ole of the button.
J
Draw thread to
reverse side of
fabric
Turn the hand wheel so the needle will enter
the right hole of the button. Readjust the
stitch width if necessary.
Stitch several times.
After you finish sewing, cut the thread but
leave 3 to 4 inches of thread at the button.
Draw the thread to the reverse side of the
fabric and knot the threads.
39