Installation Instructions; Install Leveling Feet - Kenmore Autimatic washers with Capypso wash motion Use And Care Manual

• Donothave afuse intheneutral orground c ircuit.
@
1.3 prong grounding plug
2. 3 prong grounding-type outlet
3. Ground prong
4. Power supply cord
GROUNDING INSTRUCTIONS
For a grounded, cord-connected washer:
This washer must be grounded. In the event of a mal-
function or breakdown, grounding will reduce the risk
of electrical shock by providing a path of least resist-
ance for electric current. This washer is equipped with
a cord having an equipment-grounding conductor and
a grounding plug. The plug must be plugged into an
appropriate outlet that is properly installed and ground-
ed in accordance with all local codes and ordinances.
WARNING:
Improper connection of the equipment-
grounding conductor can result in a risk of electric
shock. Check with a qualified electrician or serviceman
if you are in doubt as to whether the appliance is prop-
erly grounded.
Do not modify the plug provided with the appliance -
if it will not fit the outlet, have a proper outlet installed
by a qualified electrician.
For a permanently connected washer:
This washer must be connected to a grounded metal,
permanent wiring system, or an equipment grounding
conductor must be run with the circuit conductors and
connected to the equipment-grounding terminal or lead
on the appliance.
INSTALLATION
INSTRUCTIONS
Install the rear self-adjusting feet
1. To prevent floor damage, set the washer onto cardboard.
2. Move the washer to within approximately 3 feet (90 cm) of the
final location.
3. Prop up the rear of the washer about 4 in. (10.2 cm) with a
wood block or similar object. The block needs to suppoiff the
weight of the washer.
4. Install the self-adjusting rear feet by pushing all the way up
into the hole shown below.
_J
5. Tilt the washer forward and remove the wood block. Gently
lower the washer to the floor.
Install the front leveling feet
6. Prop up the front of the washer about 4 in. (10.2 cm) with a
wood block or similar object. The block needs to suppoit the
weight of the washer.
7. Screw the lock nut onto each foot to within 1 in. (2.5 cm) of
the base.
8. Screw the feet into the correct holes at the front corner of the
washer until the nuts touch the washer.
NOTE: Do not tighten the nuts until the washer is level.
9. Tilt the washer back and remove the wood block. Gently
lower the washer to the floor.
7