Table of Contents
Advertisement
USB connector
Description
USB connector (includes cable)
Before removing the USB connector, follow these steps:
1.
Turn off the tablet. If you are unsure whether the tablet is off or in Hibernation, turn the tablet on,
and then shut it down through the operating system.
2.
Disconnect the power from the tablet by unplugging the power cord from the tablet.
3.
Disconnect all external devices from the tablet.
4.
Remove the rear cover (see
5.
Remove the battery (see
Remove the USB connector:
1.
Disconnect the USB connector cable (1) from the system board.
2.
Remove the Phillips PM1.75×4.0 screw (2) that secures the USB connector to the
display assembly.
3.
Remove the USB connector and cable (3).
Reverse this procedure to install the USB connector.
Rear cover on page
Battery on page
16).
14).
Removal and replacement procedures
Spare part number
729741-001
23
Advertisement
Table of Contents
