Product Installation - TP-Link TL-SF1016DS Installation Manual

Note: These tools are not provided with our product. If needed, please self purchase
them.
112

Product Installation

Desktop Installation
■
To install the device on the desktop, please follow the steps:
1. Set the device on a flat surface strong enough to support the entire weight of the
device with all fittings.
2. Remove the adhesive backing papers from the rubber feet.
3. Turnover the device and attach the supplied rubber feet to the recessed areas on
the bottom at each corner of the device.
Rack Installation
■
To install the device in an EIA standard-sized, 19-inch rack, follow the instructions
described below:
1. Check the grounding and stability of the rack.
2. Secure the supplied rack-mounting brackets to each side of the device with supplied
screws, as illustrated in the following figure.
Figure 2-1 Desktop Installation
Figure 2-2 Bracket Installation
10/100Mbps Fast Ethernet Switch
Feet
Bottom of the Device
Notch
Rack-mounting Bracket
Screw
Installation
07