Cdi Settings - Garmin GPS 100 Owner's Manual

· Enter the anchor alarm distance.
· Press the CLR key to select "ON" for the anchor drag alarm.
· Move the cursor over "OK?" and press the ENT key. The anchor drag
alarm is now armed.
To turn off the anchor drag alarm...
· Move the cursor over the cyclic field to the right of the anchor drag
distance. Press the CLR key to select "OFF" for the anchor drag
alarm.
· Move the cursor over "OK?" and press the ENT key. The anchor drag
alarm is now cleared.

11.3 CDI SETTINGS

The CDI Settings Page allows you to select the characteristics of the CDI
displayed on the CDI Page (see Section 5.1 for more information on the CDI
Page).
The CDI scale, which refers to the distance that is represented by the CDI,
can be set at ±0.25, ±1.25, ±5.00, and ±10.00 distance units. For example,
if your CDI is set to ±5.00 nautical miles, the ends of the CDI represent left
and right 5.0 nautical miles of cross track error. (Some autopilots may not
perform well using the most sensitive CDI settings. In this event, you may
wish to select a less sensitive setting to avoid "hunting".)
To set the CDI scale...
CDI Orientation
CDI SETTINGS PAGE
CDI Scale
11-5