Table of Contents
Advertisement
After about two seconds, the Self Test Page will be replaced by the
Initialization Page with current date and time as illustrated below. (NOTE:
The initial position may have been set and satellite data collected at the
factory. In this event, an initial position will be shown on the Initializtion Page
below.)
The GPS 100 is ready to accept initialization data!
Initialize your GPS 100
·
Press the right or left arrow key to move the cursor over the latitude
as illustrated below.
·
Press the 2, 6, 3, 0, 3, 6 keys to enter 26°30.36'.
·
Press the ENT key to complete the latitude. The cursor will move to
the longitude as illustrated below.
·
Press the 0, 8, 1, 0, 0, 0, 0 to enter 081°00.00'.
·
Press the ENT key to complete the longitude. The cursor will move
to "OK?" as illustrated below.
15-2
Hide quick links:
Advertisement
Table of Contents
