Reviewing Waypoints; Modifying Waypoints - Garmin GPS 100 Owner's Manual

Variable rate scanning is implemented to allow you to quickly go from one end
of the list to the other. When the arrow keys are pressed briefly, you will go
through the waypoints one at a time. As you hold the arrow keys for a longer
period of time, the waypoint list will start to scroll rapidly; the longer the arrow
keys are held while scanning, the larger the step through the list.

4.5 REVIEWING WAYPOINTS

The GPS 100 allows you to quickly review waypoint information without
entering the waypoint name. For example, you may review the waypoints in
a route, or review the definition of the nearest waypoints. In general, if the
cursor is over a waypoint name, you may quickly review the definition of
that waypoint.
To review a waypoint definition...
· Move the cursor over a waypoint name and press the ENT key. The
definition of the waypoint will be displayed on the Waypoint Definition
Page with the cursor over "OK?".
· With the cursor over "OK?", press the ENT key to return to the
previous page.

4.6 MODIFYING WAYPOINTS

You may modify the position of a waypoint while viewing the Waypoint
Definition Page. (NOTE: If a waypoint is being used for navigation, its
position cannot be modified. An attempt to modify the position of such a
waypoint will result in the message "CANNOT CHNG ACTV WPT".)
To change the waypoint position by latitude/longitude entry...
· Enter the new latitude and longitude.
· Move the cursor over "OK?" and press the ENT key.
To change the waypoint position by reference...
· Enter the reference waypoint name. If the desired reference is
already there, you may skip this step.
· Enter the bearing from the reference to the desired waypoint location.
4-6