Garmin GPS 100 Owner's Manual page 84

a GOTO operation or activation of a new route.
OFFSET NAV IN EFFECT - Offset navigation mode is in effect.
OFST TOO BIG FOR RTE - The parallel track distance is too large for the
active route.
OSC NEEDS ADJUSTMENT - The GPS 100 has detected excessive drift
in its internal crystal oscillator which may result in longer acquisition time.
The unit should be taken to an authorized GARMIN service center as soon
as possible.
POOR GPS COVERAGE - The GPS 100 cannot acquire sufficient satellites
necessary to provide navigation.
PWR DOWN AND RE-INIT - The GPS 100 is unusable until power has been
cycled and the unit re-initialized. Questionable initialization data may have
been entered on the Initialization Page or abnormal satellite conditions may
exist.
PROX ALARM-PRESS NAV - Your craft has penetrated the alarm circle of
a proximity waypoint. Press the NAV key to view your position relative to the
proximity waypoint.
PROXIMITY OVERLAP - The circles defined by two proximity waypoints
overlap. When entering the area of the overlap, the GPS 100 will alarm you
of the closest proximity waypoint, but not both. You should be certain this
condition is desirable.
READY FOR NAVIGATION - The GPS 100 is ready for navigation.
RECEIVER FAILED - The GPS 100 has detected a failure in the receiver
hardware. If the message persists, the GPS 100 is unusable and should be
taken to an authorized GARMIN service center.
ROM FAILED - The GPS 100 has detected a failure in its permanent
memory. If this message occurs, the unit is unusable and should be taken
to an authorized GARMIN service center.
ROUTE IS FULL - An attempt has been made to add more than 9 waypoints
to a route. The GPS 100 will not allow more than 9 waypoints per route.
ROUTE IS NOT EMPTY - An attempt has been made to copy a route to a
13-3