Do not place objects, including rods, your fingers, etc., in the air inlet or outlet. Injury may result due to contact with the air conditioner's highspeed fan Thank you for purchasing this Daikin remote blades. controller. Carefully read this operation manual Consult your local dealer regarding relocation and before using the air conditioner.
16 FILTER SIGN RESET BUTTON AMES AND FUNCTIONS OF THE OPERATING Refer to the section of MAINTENANCE in the SECTION operation manual attached to the indoor unit. figure 1, (figure 1B shows the remote controller with 17 INSPECTION/TEST OPERATION BUTTON front cover opened) This button is used only by qualified service persons for maintenance purposes.
Placing the remote controller in the remote ANDLING FOR WIRELESS REMOTE CONTROLLER controller holder Precautions in handling remote controller Install the remote controller holder to a wall or a pillar with the attached screw. Make sure the remote controller Direct the transmitting part of the remote controller to transmits.
PERATION RANGE ON/OFF Refer to the operation manual provided with the indoor unit or with the outdoor unit. Press ON/OFF button. If the indoor temperature or humidity is beyond OPERATION lamp lights up or goes off and the operating conditions as listed in the indoor unit or system starts or stops OPERATION.
Explanation of heating operation FAN SPEED CONTROL Defrost operation Press FAN SPEED CONTROL button. As the frost on the coil of an outdoor unit increase, High or Low fan speed can be selected. heating effect decreases and the system goes into DEFROST OPERATION.
Program timer operation TIMER CANCEL Operate in the following order. The timer is operated in the following two ways: Press the CANCEL button to cancel programming. The display vanishes. - Programming the stop time ( For example. The system stops operating after the set time has When the timer is elapsed.
designate master remote Precautions for group control system or two controller remote control system This system provides two other control systems beside Operate in the following order. individual control (one remote controller controls one indoor unit) system. Confirm the following if your unit is of the following control system type: Group control system Continuously...
Trouble The RUN lamp of the indoor unit is flashing and the unit does not work at all. See figure Press OPERATION MODE SELECTOR button. Malfunction code " " on the left-hand of the malfunction code blinks. Unit No. which sensed trouble INSPECTION display Remedial action Press PROGRAMMING TIMER button and change...
Page 11
Symptom 2: The unit stops once in a while Symptom 7: No indication shows or all indication show Example Reason Example Reason The remote controller Due to electrical noise indicates "U4" and "U5", other than that from the When the remote The battery is dead.