REAR COVER FN116120007 SCREW FN130203179 FN116120008 OIL DIPSTICK FN012089000 CIRCLIP FN015083000 CASING COVER GASKET FN116120016 Thank you for purchasing this Clarke CHAMP Air Compressor which is fitted with a SCREW FN014002128 CRANKSHAFT FN116CN0017 3 litre air reservoir. COVER FN116NC0003 CASING FN116120006...
Page 4
Safety Precautions Parts Diagram WARNING! As with all machinery, there are certain hazards involved with their operation and use. Exercising respect and caution will considerably lessen the risk of personal injury. However, if normal safety precautions are overlooked, or ignored, personal injury to the operator, or damage to property may result. It is in your own interest to read and pay attention to the following rules: WARNING When using the air compressor, you should follow basic safety precautions...
Safety Precautions TRAINING: Prior to use all operators should become familiar with the instructions in With considerate use, your Clarke CHAMP Air Compressor should provide you this booklet. In particular, become familiar with the ON/OFF control for emergency with long and trouble free service. Routine checks should be made on both the stopping.
After the first 100 hours use, replace the ONLY USE PARTS AND ACCESSORIES RECOMMENDED IN THIS MANUAL: The use of oil completely using Clarke SAE40 unauthorised accessories or attachments is not permitted and may result in compressor oil. Then replace the oil after personal injury and damage to the air compressor.
Page 7
DO NOT MODIFY THE AIR COMPRESSOR: Do not attempt to modify the air compressor, page 12 and top-up if necessary - (use Clarke SAE 40 compressor oil, available tank, fittings or attachments in any way. Doing so will invalidate the guarantee from your local dealer).
Safety Precautions Operating Instructions Draining the reservoir NEVER STOP THE COMPRESSOR BY REMOVING THE PLUG OR SWITCHING OFF AT THE MAINS SUPPLY: Always use the On/Off switch on the compressor. NEVER OPERATE WITHOUT ALL GUARDS IN PLACE: Never operate without all guards CAUTION! It is important to drain the reservoir before storage.
Operating Instructions Warning Symbols Switching the air compressor OFF READ THIS INSTRUCTION BOOKLET CAREFULLY BEFORE POSITIONING, OPERATING OR ADJUSTING THE To switch the air compressor off, COMPRESSOR. 1. Close the outlet tap and press down on the on/off button (red button). 2.
Electrical Connections Operating Instructions 110V Model Switching the air compressor ON Connect the mains lead to a suitable 110V (50Hz) electrical supply through anapproved plug to BS4343, or a suitably fused isolator switch. If using a portable 110V transformer, The compressor will make a continuous loud noise when the tank is charging - make sure it has a rated capacity sufficientto take the load of the air compressor (see this is normal.
Preparing for Use Parts Identification Before connecting your compressor to the mains supply, check the following:- • The mains voltage is 230V. • The ON/OFF switch is in the OFF (lower) position. • The pressure regulator should be set at its lowest setting, i.e. turned fully anticlockwise.
15 ). See figure 1, and ensure that it is completely stable. • If needed top up the reservoir with Clarke SAE 40 compressor oil, available from your Clarke dealer. Do not cover or box in the compressor.
Need help?
Do you have a question about the CHAMP 265 and is the answer not in the manual?
Questions and answers