Related Manuals for Clarke 6240056
Summary of Contents for Clarke 6240056
- Page 1 CORDLESS COMPRESSOR WITH SPOTLIGHT + JUMP START MODEL NO: CSS1 PART NO 6240056 OPERATING & MAINTENANCE INSTRUCTIONS GC1014...
-
Page 2: Environmental Protection
INTRODUCTION Thank you for purchasing this CLARKE product. Before attempting to use this product, please read this manual thoroughly and follow the instructions carefully. In doing so you will ensure the safety of yourself and that of others around you, and you can look forward to your purchase giving you long and satisfactory service. -
Page 3: General Safety Rules
The unit is designed for use with 12V systems. Do not operate the unit if the case is damaged. Consult your Clarke dealer or a qualified person for inspection and repair. 5. To prevent the battery from overheating and consequent damage, do not exceed 6 seconds duration time when jump starting. -
Page 4: Safety Symbols
SAFETY SYMBOLS Class II appliance Always read instructions before use Electrical Hazard due to exposed live terminals Chemical Hazard from battery acid USB Port Live centre pin Suitable for indoor use only (refers to mains adaptor only) Subject to Waste Electrical & Electronic Directive Parts &... - Page 5 OVERVIEW NO DESCRIPTION NO DESCRIPTION Control Switches Pressure Gauge DC 12V Socket Spotlight LED Lights USB Charger Air Hose Storage Charging Jack Socket Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com...
- Page 6 CHARGING TO ENSURE MAXIMUM LIFE FROM THE BATTERY. • Charge this unit before using it for the first time. • Recharge after every use if possible, and thereafter, once every three months. Always avoid leaving the unit in a state of discharge. CHARGING USING THE MAINS ADAPTOR 1.
-
Page 7: Operation
USING THE CSS1 VIA THE CAR CIGARETTE SOCKET 1. With the vehicle running, Connect the end of the 12V male-to-male car power cord which does not had a LED light on it to the DC 12V socket on your CSS1. 2. - Page 8 USING THE USB CHARGER 1. Insert the USB cable into the USB socket on the side of the unit. 2. Press the USB switch on the top of the unit. • This will supply a maximum 5V at 500mA USING THE EMERGENCY CAR STARTER WARNING: FAILURE TO FOLLOW THE INSTRUCTIONS BELOW AND THE SAFETY INSTRUCTIONS ON PAGE 4, MAY RESULT IN PERSONAL INJURY, DAMAGE TO THE VEHICLE, OR THE POSSIBILITY OF AN EXPLOSION.
-
Page 9: Maintenance
3 kg Please note that the details and specifications contained herein, are correct at the time of going to print. CLARKE International reserve the right to change specifications at any time without prior notice. Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com... -
Page 10: Declaration Of Conformity
DECLARATION OF CONFORMITY Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com... - Page 11 NOTES Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com...
Need help?
Do you have a question about the 6240056 and is the answer not in the manual?
Questions and answers