Water Filtration System - KitchenAid W10515677B Use & Care Manual

1. Move theicemaker toitsfinal l ocation.
NOTE: Ifthisisa built-in installation, move theicemaker as
close aspossible tothefinal l ocation.
2. Place thelevel o ntopoftheproduct tosee whether theice
maker islevel from front t oback and side toside.
3. Push uponthetopfront o ftheicemaker, and then locate the
leveling s crews thatareonthebottom front o ftheicemaker.
4. Using anadjustable wrench, change t heheight ofthelegs as
follows:
• Turn theleveling legtotheright t olower t hatsideofthe
icemaker.
• Turn theleveling legtothelefttoraise thatsideoftheice
maker.
NOTE: The icemaker should notwobble. Use shims t oadd
stability w hen needed.
5. Push uponthetoprear o ftheicemaker andlocate the
leveling l egs thatareonthebottom rear o ftheicemaker.
6. Follow theinstructions inStep 4tochange t heheight ofthe
legs.
7. Use thelevel torecheck theicemaker toseethatitiseven
from front t oback and side toside. I ftheicemaker isnot
level, repeat steps 2 to5.Iftheicemaker islevel, gotothe
"Connect Water S upply" section.
Water F Itrat on System
Do not use with water that is microbiologically unsafe or
of unknown quality without adequate disinfection before
or after the system. Systems certified for cyst reduction
may be used on disinfected waters that may contain
filterable cysts.
Install the Water Filter
1. Locate the accessory packet in the ice maker and remove the
water filter.
2. Take the water filter out of its packaging and remove the
cover from the O-rings. Be sure the O-rings are still in place
after the cover is removed.
B D
C
3. The water filter compartment is located in the right-hand side
of the ice maker control panel.
4. Attach the filter wrench to the water filter.
5. Align the alignment pin on the side of the filter with the cutout
notch in the control housing and insert the filter into the
housing.
A
C
6.
A. Afignment pin
B. Unlocked symbol
(
C. Locked symbol
D. Cutout notch in control housing
Turn the filter clockwise until it locks into the housing. Ensure
that the alignment arrow on the filter head aligns with the
locked symbol on the control box housing.
NOTE: If the filter is not correctly locked into the housing, the
ice maker will not produce ice.
A. Afignment arrow aligned with locked symbol
7. Remove the filter wrench.
A. Cover C. Alignment pin
B. O-rings D. Alignment arrow
10