Install Leveling Legs - Kenmore Elite Sensor smart 27-inch wide electric dryers Owner's Manual And Installation Instructions

B. INSTALL LEVELING LEGS
Leveling your dryer correctly will
reduce operating noise and provide
improved drying performance.
STEP 4. Start to screw the legs into the
holes by hand. Use a wrench to finish
turning the legs until diamond marking
is no longer visible. This is when we
recommend you start checking the dryer
for levelness. Further adjustment may
be necessary.
!
Excessive Weight Hazard
|
Use two or more people to move and
install dryer. I
Failure to do so can result in back or I
other injury. I
STEP 1. Take two of the cardboard
corners from the carton. Place them
on the floor in back of the dryer.
STEP 2. Firmly grasp the body of the
dryer (not the top or console panel).
Gently lay dryer on the cardboard
corners.
STEP 3. With one of the legs in hand,
check the ridges for a diamond marking.
STEP 5. Stand the dryer up and move
it close to its final location. Leave enough
room to connect the exhaust vent.
STEP 6. Check levelness of dryer by
placing a level on top of the dryer, first
side-to-side; then front-to-back.
STEP 7. If dryer is not level, prop the dry-
er up using two stacked cardboard cor-
ner posts. Use a wrench to adjust the
legs up or down.
I
12
NOTE: It may be necessary to level
the dryer again after it is moved into
its final position.