Kenmore Elite Sensor smart 27-inch wide electric dryers Owner's Manual And Installation Instructions page 47

IV t'_im,'t'_,'_a "-I_i1=% _I,,m
Most laundering problems are easily solved if you understand the cause. Using
the tables below will save you time and money by helping you avoid
unnecessary service calls.
Problem Possible Cause
Message Codes
"PF" Dryer connected to power supply
(Power Failure} during installation or power
failure.
Drying cycle interrupted
by power failure.
"El" or "E2" Service required.
Not Drying Lint screen is clogged with lint.
Satisfactorily Restricted air movement.
Exhaust vent or outside
exhaust hood is clogged with lint.
8olution
Press STOP/CANCEL to clear display.
Press STARTto restart the dryer.
Call for service.
Clean Iint screen.
Run dryer for 5-10 minutes. Hold
hand under outside exhaust hood to
check air movement. If you do not feel
air moving, clean exhaust system of
Iint or replace exhaust vent with rigid
metal or flexible heavy metal vent
(see "INSTALLATION," Section D).
Exhaust vent is crushed Replace with heavy metal or flexible
or kinked, metal vent
(see "INSTALLATION," Section D).
One fuse is blown or circuit Replace fuse or reset breaker.
breaker is tripped. The dryer
will appear to operate, but
you will not get any heat.
AIR DRY Cycle has been Select the right cycle for the types
selected, of garments being dried
(see "OPERATION").
Load not contacting the Level dryer
sensor strips and automatic (see "INSTALLATION," Section B).
cycle ending early.
Fabric softener sheets Use only one softener sheet per load
blocking outlet grill, and only use it once.
Dryer located in room with Move dryer where it can operate in
temperature below 45°R ambient air temperatures above 45°R
Large amount of moisture Expect longer dry times with items
in the load. that hold more moisture (cottons).
Cold rinse water used. Expect longer dry times, but you are
saving energy and reducing wrinkles.
Load too large and bulky to Separate Ioad to tumble freely.
dry quickly.
47