Kenmore Elite Sensor smart 27-inch wide electric dryers Owner's Manual And Installation Instructions page 20

GROUNDING INSTRUCTIONS
This appliance must be grounded. In
the event of malfunction or breakdown,
grounding will reduce the risk of electric
shock by providing a path of least
resistance for electric current. The
power supply cord must be plugged
into an appropriate outlet that is
properly installed and grounded in
accordance with all local codes and
ordinances.
WARN ING: Improper connection
of the equipment-grounding conductor
can result in a risk of electric shock.
Check with a qualified electrician or
serviceman if your are in doubt as to
whether the appliance is properly
grounded.
Do not modify the plug on the power
supply cord. If it will not fit the outlet,
have a proper outlet installed by a
qualified electrician.
SAVE THESE INSTRUCTIONS
STEP 1. Disconnect power.
STEP 2, Remove hold-down screw
and terminal block cover.
Hold-down screw
STEP 3. Attach a g-inch, U.L.-listed strain
relief to the hole below terminal block
opening. Strain relief should have
a tight fit with dryer cabinet and be in a
horizontal position. Put the power supply
cord through the strain relief.
STEP 4. Remove the center terminal block
screw. Remove the neutral grounding wire
(green/yellow wire) from external ground-
ing screw.
External ground Center silver-colored
connector terminal block screw
Green/yellow wire
of harness
Terminal block cover
2O