Epson TM-U950P - B/W Dot-matrix Printer Specification page 6

REV. SHEET
Section 5.3, Customer Display
B 46
DM-D202 and DM-D101 ® DM-D202II and DM-D101II
Bit 3: Bit 3 is not transmitted ... ® Becomes 0 ...
52
53 DLE ENQ n - [Note]
ù When the printer recovers from ... Therefore, ..., select two-sheet
mode again ..." ®
ù When the printer recovers from ... Therefore, ..., select slip mode
again ..."
53-1 [Notes when the printer is used with the MICR reader]
[Reference when the printer is used with the MICR reader [Addition]
Section 6.4, MICR Control Commands
95 104
to
DLE EOT BS n, FS a 0 n, FS a 1, FS a 2, FS b, FS c
App.2 Table: when the printer is used with the MICR reader
App.10 APPENDIX I: Example Read Control for MICR Characters
App.11
C 8
Figure 1.9.2 Slip Paper Printable Area 8.3mm(.33")®8.0mm(.31")
9 3) Lengthwise printing
ùPaper fed per step 0.1771mm(.0007")®0.1764mm(.00069")
ùFrom the top of the slip to the printing position
Figure 1.9.3 U.S.A. Personal Check Printable Area
D
I GENERAL DESCRIPTION
17 - 17-4 Section 2.1.2 IEEE-P1284 Bidirectional Parallel Interface [Addition]
17-5 Section 2.1.3 Reception of Status from Printer through Bidirectional
Parallel Interface
18 Figure 2.2.2 Schematic View of Parallel Interface Connector Panel
21 (RS-232 Interface Specifications)
23 ESC c 3
35-1 Description for Parallel Interface Specifications
70-1 ESC c 3
94 Ignored Command ESC c 3 (Available only with Serial Interface)
12-29 APPENDIX J. Bidirectional Parallel Interface
App.
TITLE
REVISION SHEET
CHANGED CONTENTS
8.7mm (0.34"=A) ® 8.0mm (0.31"=A)
A=8.7mm(.34") ® A=8.00(.31")
TM-U950/U950P
Specification
(STANDARD)
Sheet 5 of 10
DATE
[Change]
[Correction]
[Correction]
[Addition]
[Addition]
[Addition]
[Addition]
[Addition]
[Addition]
[Addition]
[Addition]
[Addition]
[Addition]
[Addition]
[Addition]