Epson TM-U950P - B/W Dot-matrix Printer Specification page 24

ù Since the slip ejection sensor uses a reflective photo sensor, do not use paper that has holes or
dark portions with low reflection (less than 40% reflection) at the sensor position (refer to Figure
1.8.3).
ù Be sure to perform slip printing with a paper roll loaded to avoid incorrect paper feeding due to
paper jams.
ù Use thinner paper (N30 or equivalent) between the top and bottom sheets of multi-ply paper. If
thick paper is used, the copy capability is lowered.
7) Notes on using the MICR reader (only when the printer is used with MICR)
ù Be sure to perform personal check printing with a paper roll loaded. If MICR reading and/or
printing is performed without a paper roll loaded, the check cannot be fed correctly or may be
damaged due to paper jams.
ù The personal checks must be flat, without curls, folds, or wrinkles (especially at the edges).
Otherwise, the check may rub against the ribbon and become ink-stained.
ù Do not insert checks with staples. This may cause paper jams, MICR reading errors, and damage to
the MICR head.
ù Let go off the check immediately as soon as the printer starts feeding it. Otherwise, the paper is
not fed straight, causing paper jams and MICR reading errors.
EPSON
TITLE
TM-U950/U950P
Specification
(STANDARD)
SHEET NO.
REVISION
NEXT
B
A
8 7
SHEET
6-1 7