Table of Contents
Advertisement
Installation Instructions
STEP 14 CONNECT WATER SUPPLY
Connect water supply line to the 90° elbow.
• Slide compression nut, then ferrule over end of water line.
• Insert water line into 90° elbow.
• Slide ferrule against elbow and secure with compression nut.
IMPORTANT
– Check to be sure that door spring
does not rub or contact the fill hose or water supply line. Test
by opening and closing the door. Reroute the lines if a rubbing
noise or interference occurs.
STEP 15 CONNECT DRAIN LINE
FOLLOW ALL LOCAL CODES AND ORDINANCES.
The molded end of the drain hose will fit 5/8" through 1"
diameter inlet ports on the air gap, waste tee or disposer.
• Determine size of inlet port
• Cut drain hose connector on the marked line, if required, to fit
the inlet port.
IMPORTANT: Do not cut corrugated
Cutting Line
1"
5/8"
Figure FF
• If a longer drain hose is required, add up to 42" of length for
a total of 10' to the factory installed hose. Use 5/8" or 7/8"
inside diameter hose and a coupler to
923-10A
connect the two
hose ends.
Secure the
connection with
hose clamps.
����������
Figure GG
• Secure the drain hose to the air gap, waste tee or disposer
with clamps.
Note: TOTAL DRAIN HOSE LENGTH MUST NOT EXCEED 10' FOR
PROPER DRAIN OPERATION.
DRAIN LINE INSTALLATION
• Connect drain line to air gap, waste tee or disposer using
either previously determined method.
10
portion of hose
����������
�������
����������
Figure EE
Method 1 – Air gap with waste tee or disposer
Insert the drain hose to air gap as shown.
Waste Tee Installation
Figure HH
�������
Method 2 – Drain Hose Routing
Route the drain hose of the dishwasher to a minimum height of 32" from
Fasten drain hose at least at
the floor with the supplied hanger as shown.
32" height with hanger supplied
32"
Min.
18"
Min.
Waste Tee Installation
Figure JJ
05A-1183FF
IMPORTANT
– Either one of the above methods
must be used or dishwasher will not operate properly.
IMPORTANT
– When connecting
drain line to disposer, check to be sure
that drain plug has been removed.
DISHWASHER WILL NOT DRAIN IF
PLUG IS LEFT IN PLACE.
Tip: Avoid unnecessary service call charges. Always be sure
disposer drain plug has been removed before attaching
dishwasher drain hose to the disposer.
Compression Nut
Ferrule
Hot Water
90° Elbow
Supply Line
90° Elbow
Door Spring
05A-1183CC
Disposer Installation
�������
Fasten drain hose at least at
32" height with hanger supplied
32"
Min.
18"
Min.
Disposer Installation
05A-1183GG
�������
������
������
����
Advertisement
Table of Contents
