Step 13 - Connect Drain Line; Drain Line Installation - GE GLDT690JWW Installation Instructions Manual

STEP 13 – CONNECT DRAIN LINE
FOLLOW ALL LOCAL CODES AND ORDINANCES.
The drain hose molded end will fit 5/8", 3/4" or 1"
diameter connections on the air gap, waste tee or
disposer. Cut on the marked line as required for your
installation.
Cutting Lines
Cutting Lines
3/4"
1"
IMPORTANT: Do not cut corrugated
IMPORTANT: Do not cut corrugated
por tion of hose
• If a longer drain hose is required, add up to 42" of length
for a total of 10 ft. to the factory installed hose.
Use 5/8" or 7/8" inside diameter hose and a coupler to
connect the two hose ends. Secure the connection with
hose clamps.
Hose Clamp
Hose Clamp
• Secure the drain hose to the air gap, waste tee or disposer
with clamps.
NOTE: TOTAL DRAIN HOSE LENGTH MUST NOT EXCEED
10 FEET FOR PROPER DRAIN OPERATION.
10
Installation Instructions
5/8"
portion of hose
Hose Clamp
Coupler
Coupler

DRAIN LINE INSTALLATION

• Connect drain line to air gap, waste tee or disposer using
either previously determined method.
Method 1 - Air gap with waste tee or disposer
Waste Tee Installation
Method 2 - High drain loop with waste tee or disposer
Fasten to underside
of countertop
32"
Min.
18"
Min.
Waste Tee Installation
IMPORTANT -
When connecting drain line to
disposer, check to be sure that
drain plug has been removed.
DISHWASHER WILL NOT DRAIN
IF PLUG IS LEFT IN PLACE.
TIP: Avoid unnecessary service call charges. Always be sure
disposer drain plug has been removed before attaching
dishwasher drain hose to the disposer.
Disposer Installation
Fasten to underside
of countertop
18"
Min.
Disposer Installation
Remove
Drain
Plug