Advertisement
Risk of scalding or other severe injury.
S Before completing installation, the installer must set the maximum
water temperature setting of this valve to minimize the risks
associated with scalding hazards according to ASTM F 444.
S Do not install a shut off device on either outlet of this valve. The
installation of any such device may create a cross flow condition at
the valve and affect the water temperature.
S Factors that change the temperature of the water supplied to the
valve, such as seasonal water temperature changes, and water heater
replacement or servicing, will change the maximum water
temperature supplied by the valve and may create a scalding hazard.
The pressure balanced valve will not compensate for changes in the
water supply temperature; adjust the maximum water temperature
setting of this pressure balanced valve when such changes occur.
S Pressure balanced valves may not provide protection against scalding
if there is a failure of other temperature limiting devices elsewhere in
the plumbing system.
If you do not understand any of the installation or temperature
adjustment instructions in this document, in the United States please
contact our Customer Service Department at 1-800-4-KOHLER. Outside
the U.S. please contact your distributor.
: Please fill in the blanks below and on the valve label.
Then insert these instructions into the plastic bag included with the
valve package, and attach the plastic bag to the valve handle for the
owner's reference.
114552 2
Kohler Co., Kohler, WI
2
Advertisement
