Related Manuals for Kohler Coralais Rite-Temp 114522-2-CE
Summary of Contents for Kohler Coralais Rite-Temp 114522-2-CE
- Page 1 INSTALLATION G U I D E CORALAISt RITE TEMPt BATH AND SHOWER FAUCET 114552 2...
- Page 2 If you do not understand any of the installation or temperature adjustment instructions in this document, in the United States please contact our Customer Service Department at 1-800-4-KOHLER. Outside the U.S. please contact your distributor. : Please fill in the blanks below and on the valve label.
-
Page 3: Before You Begin
Hacksaw or Adjustable Strap Pipe Tubing Cutter Wrench Wrench Wrench Assorted Plumbers Thread 5/32" Propane Solder Screwdrivers Putty Hex Wrench Sealant Torch BEFORE YOU BEGIN CAUTION: Risk of product damage. SPECIAL NOTE NOTE K-304 K-308 Kohler Co., Kohler, WI 114552 2... -
Page 4: Prepare Site
PREPARE SITE ROUGH IN PLUMBING NOTE To improve clarity, the plaster guard dome is not shown in Shut off the main water supply. some of the illustrations. If the bathing fixture has been installed, cover the fixture to SUPPORT FRAMING prevent damage to the surfaces. - Page 5 Supply Stop Nut will extend at least 2" (50cm) Temporary Stem beyond the finished wall. Nipple Assembly If the inner valve components had been removed for soldering, reinstall them now. Kohler Co., Kohler, WI 114552 2...
-
Page 6: Installation Checkout
Back to Back Installation: 180_ INSTALLATION CHECKOUT INSTALL WALL Thick Wall Installation (Tile, Plaster, Marble, etc.) - Page 7 Secure the backing plate to the back of the wall material. Do not remove the dome until Wall Backing Plate instructed. Material 4" (10.2cm) D. Plaster Guard 2 3/4" (7cm) Rough In Depth Kohler Co., Kohler, WI 114552 2...
- Page 8 - 2 7/8" (7.3cm) Spouts For a slip fit spout, Setscrew 5/32" Wrench Threaded Spouts Nipple Apply Plumbers Putty 3 7/8" Standard (9.8cm) Spouts Nipple For a threaded spout, Apply Plumbers Putty 7" (17.8cm) 8" (20.3cm) Spouts Kohler Co., Kohler, WI 114552 2...
- Page 9 Press the escutcheon against the finished wall. Remove any excess putty. With the showerhead off, flush the system. Apply thread sealant tape to the shower arm and install the showerhead to the shower arm. Kohler Co., Kohler, WI 114552 2...
- Page 10 Slide the O ring into the valve stem groove. Rotate the valve stem counterclockwise to shut the water off. Reinstall the handle and face plate. Kohler Co., Kohler, WI 114552 2...
- Page 11 Plaster Guard w/Dome Discard Rotate the valve stem fully Face Plate counterclockwise. Install the handle and face plate onto the valve and carefully secure with screws. Do not overtighten the screws. Screws Kohler Co., Kohler, WI 114552 2...
- Page 12 For additional assistance in the USA, call our Customer Service Department for direct help. You may also contact us at our web site listed below. 1 800 4 KOHLER kohler.com Kohler Co., Kohler, WI 2002 Kohler Co.