Recahbrating Your Oven Temperature - Kenmore Slide-in 790.4635 Use & Care Manual

To Remove and Replace the Storage Drawer
Use the storage drawer for storing cooking utensils. The drawer can de removed to facilitate cleaning under the range. Use
care when handling the drawer.
To open the storage drawer, push the drawer in gently and it will spring open. To close, push the drawer until you hear a
click, which indicates that the spring is compressed, and the drawer is closed.
Frame
Storage
Drawer
To remove the drawer:
1. Pull empty drawer out to the roller guide stop.
2. Tilt the drawer up and pull it out over tile rollers.
To replace the drawer:
1. Insert the rear end of the drawer into the opening.
2. Fit the drawer end rollers onto the guide rails.
3. Push the drawer in until it stops, then lift to allow the rollers to clear tile roller guide
stop, and push in.
RecaMibrating Your Oven Temperature
Your oven thermostat has been precisely set at the factory. This setting may differ from your previous oven, however, so your
recipe times may not give you the results you expect. If you think that the oven is cooking too hot or cool for your recipe times,
you can adjust the thermostat so that the oven cooks hotter or cooler than the temperature displayed.
To Adjust Oven Temperature:
1. Push the BAKE pad Q.
2. Set the temperature to 550% (287°C) by pushing and holding the UP ARROW pad A.
3. Within 2 seconds, push and hold the BAKE pad _ until the special 2 digit display appears. Releasethe BAKE pad _-'_.
The display now indicates the amount of degrees offset between tile original factory temperature setting and the current
temperature setting. If tile oven control has the original factory calibration, tile display will read "00."
4. The temperature can now be adjusted up or down 35°F (!7°C), in 5°F (1°C) steps by pushing and holding the UP A or
DOWN ARROW pad v. Adjust until the desired amount of degrees offset appears in the display. When lowering the oven
temperature, a minus sign (-) will appear before the number to indicate that the oven will be cooler by tile displayed
amount of degrees.
5. When you have made the desired adjustment, push tile STOP CLEAR pad _ to go back to the time of day display.
Note: Tile adjustment made will not change the self-cleaning temperature.
24