Buttonhole Function - Kenmore 385.16231400 Service Manual

SEWING MACHINE DIV.20 MODEL 385. 16231300
MECHANICAL ADJUSTMENT
BUTTONHOLE FUNCTION (3)
THE MACHINE WILL STOP AUTOMATICALLY WHEN BUTTONHOLE IS COMPLETED. IF THE
MACHINE STOPS TOO EARLY OR TOO LATE, CORRECT IT AS FOLLOWS:
ADJUSTMENT PROCEDURE:
1. OPEN THE FACE COVER.
2. LOOSEN THE SETSCREW (A).
3. IF THE MACHINE STOPS TOO EARLY: MOVETHEADJUSTINGPLATE(B) INTHE
DIRECTION OF (C).
4. IF THE MACHINE STOPS TOO LATE OR DOES NOT STOP: MOVETHEADJUSTINGPLATE
(B) IN THE DIRECTION OF (D).
5. TIGHTEN THEADJUSTING SCREW (A).
6. ATrACH THE FACE COVER.
NOTE: IF THE MACHINE WILL NOT STOP WHEN PUSHING THE BH LEVER IN THE DIRECTION
OF THE ARROW, ADJUST THE POSITIONNN OF THE MICRO SWITCH AS FOLLOWS.
1. SEW UP TO STEP 4 AND STOP THE MACHINE. REMOVE THE BELT COVER.
2. LOOSENTHESETSCREW(E).ADJUSTTHEGAPTO1 MMBYSHIFTING THESWlTCH
HOLDER (F) SO THE MICRO SWITCH (G) IS ON. TIGHTEN THE SET SCREW (E).
3. SEW A TEST BUTTONHOLE TO CHECK IF THE MACHINE STOPS AUTOMATICALLY.
4. ATTACH THE BELT COVER.
O X
3
MICRO SWITCH SHOULD
2 _ 4 BEON ATTHISPOSITION" _
_ __/MACHINE SEWSA FEW -- MACHINE STOPSTOO
AUTOMATICALLY.
(A)
BH LEVER
/
(G)
/
37