Table of Contents
Advertisement
pebbles or sand could be sucked into
the jet intake, causing impeller dam-
age and engine overheating.
(3) Attach the engine shut-off cord (lanyard)
to your left wrist, and then attach the clip
to the engine shut-off switch. It is not pos-
sible to start the engine with the clip re-
moved from the engine shut-off switch.
WARNING! Check that the engine
shut-off cord (lanyard) is attached cor-
rectly. If the engine shut-off cord (lan-
yard) is not attached correctly, it may
not pull free when the operator falls
off, allowing the watercraft to continue
to run and cause an accident.
1
3
1 Clip
2 Engine shut-off switch
3 Engine shut-off cord (lanyard)
(4) Push the start switch (green button), and
then release it as soon as the engine
starts to run. If the engine does not start
[ECJ00471]
EJU32861
Stopping the engine
To stop the engine, release the throttle lever,
and then push the engine stop switch (red
button). WARNING! You need throttle to
[EWJ00581]
steer. Shutting the engine off can cause
you to hit an obstacle you are attempting
2
to avoid. A collision could result in severe
injury or death.
in 5 seconds, release the start switch,
wait 15 seconds, and then try again. The
engine will not start if the throttle lever is
squeezed. NOTICE: Never push the
start switch while the engine is run-
ning. Do not operate the start switch
for more than 5 seconds, otherwise
the battery will be discharged and the
engine will not start. Also, the starter
motor could be damaged.
[EWJ00601]
Operation
[ECJ01040]
70
Advertisement
Table of Contents
